Vancouver Boiler Repairs, Boiler Service and Boiler Installation
Papa Manj from your local Richmond plumbing and heating company explains a boiler service. This particular boiler install was done in Surrey today. This week alone, we performed a Langley boiler installation, a Vancouver furnace installation and a Burnaby air conditioner installation. Its been a busy week ! These are the main points that Richmond plumbing and heating technicians will go through when they visit your home:
- Richmond plumber will Check operation of safety limit control controls.
- Richmond plumber will Check pressure relief valve.
- Richmond plumber will Check water pressure and temperature set points.
- Richmond plumber will Check expansion tank.
- Richmond plumber will Check operation of thermostat.
- Richmond plumber will Lubricate circulating pump as required.
- Richmond plumber will Check radiant floor temperature control device (mixing valve or equipment).
- Richmond plumber will Check pressure switches and vent blower (if applicable).
- Richmond plumber will Inspect burners and clean if required.
- Richmond plumber will Examine vent connector and inspect venting system.
- Richmond plumber will Check the vent damper operation (if applicable).
- Richmond plumber will Check and adjust pilot light (if applicable).
- Richmond plumber will Check flame rectification.
- Richmond plumber will Measure the stack (flute) temperature.
- Richmond plumber will Check gas piping to boiler.
- Richmond plumber will Check and adjust manifold gas pressure.
- Richmond plumber will Clock appliance to verify correct input.
- Richmond plumber will Combustion / ventilation air adequate.
- Richmond plumber will Check for elevated carbon monoxide levels.
- Richmond plumber will Inspect heat exchanger.
- Richmond plumber will Check temperature difference between supply and return piping.
- Richmond plumber will Check for Carbon Monoxide.
Hope you find this video helpful !

